Vandy Vape RATH RDA Review

VandyVape Rath RDA review

VandyVape Rath RDA

Review Score
  • Various Airflow Adjustment Methods
  • Support Single/Dual Heating Wire
  • The build deck is very easy to build and to wick
  • Deep Groove With Large E-Liquid Storage
  • Perfect for single or dual coils
  • Ceramic +/- Electrodes
  • Ceramic electrodes cannot be screwed vigorously

A rebuildable dripping atomizer, or an RDA for short, is a kind of vape that’s different from the one you normally find in the market. It’s used for dripping, a form of vaping where the vape liquid is directly dripped onto the heating coils of the atomizer instead of being stored in the tank.


Here, we look at the VandyVape Rath RDA, a single coil RDA; however, a dual coil configuration might also be possible.

VandyVape Rath RDA

Package Includes:

1 x Vandy Vape RATH RDA

2 x Fused Clapton Coil 0.33ohm

1 x Drip Tip

1 x Spare Parts Bag

1 x Instruction Manual


  • 24mm Diameter
  • 6mm Deep Juice Wells
  • Superior 304 Stainless Steel Construction
  • Postless Clamp-Style Build Deck
  • PEEK Insulator
  • Side Secured via Flathead Screws
  • Single or Dual Coil Configuration
  • Dual Honeycomb Airflow Control Cap
  • Widebore Drip Tip
  • BF 510 Squonk Pin

VandyVape Rath RDA Description

The barrel comes with an array of two honeycomb style air intake holes. The air can be adjusted by spinning the top cap. The top cap itself acts as an 810 drip tip; however, the bag of parts in the packing comes with an 810 to 510 drip tip adapter with an aesthetic resin tip.


You can also use it as a bottom feeder by removing the two stock pins for the positive terminal at the bottom and installing the bottom-feeding pin provided in the packaging. Note that it requires an Allen key to screw in place, which should also come with the spare parts.

VandyVape Rath RDA3

VandyVape Rath RDA Insight

The stainless steel body ensures that you get a high-quality and durable RDA. Plus, it ensures that there is adequate sealing between the top cap of the barrel and the barrel’s body, preventing air ingress from these points.


The top cap’s air holes are not aligned with where the coils get placed on the build deck; however, their angle of attack is inclined downwards so that air flows down to the wick.


The clamping style posts with ceramic clamps and screws for adjusting and tightening the coils. You can’t change the style of the posts as the screws and clamps come as a single unit.


The top cap is dome-shaped from the inside with thick walls. As a result, it doesn’t leave much space for building a 2-coil configuration. In addition, the clamp posts terminals have slots for accepting another coil; however, each post is a single terminal (positive or negative), meaning the second coil must sit on top of the other coil in order to get a two coil configuration. If installed incorrectly, the two coils may short out. In that case, it’s best to stick with a single-coil construction.

Leave a Reply

Your email address will not be published. Required fields are marked *